Air Intake (plenum)

Machine monkey · Post by **Machine monkey** » Wed Dec 06, 2017 8:41 am

Anyone know if they are all the same? 2.2-2.5-3.0?

Has anyone got spare? I could take mine off my car but I am only thinking about an idea and just need to look one over and check some things. Ideally a 3.0l one would be great.

The idea
I want to build a less complicated equal flow plenum for my turbo build. The plastic one on the car will be holding me back. Making the plenum is no problem for me. It’s the matting it to the engine that causes some issues. On older m50 engines it looks like it’s possible to use the lower part that connects to the head and then using silicone connectors to connect to the aluminium part I will be making. If this is possible for M54 it’s a very easy job.

markplant · Post by **markplant** » Wed Dec 06, 2017 10:26 am

Realoem should tell you all other models that the part was used on, I'll try an have a look

markplant · Post by **markplant** » Wed Dec 06, 2017 10:30 am

: Screenshot_20171206-092918.png (209.19 KiB) Viewed 667 times

Is it part no 1
It's 3.0 specific

Machine monkey · Post by **Machine monkey** » Wed Dec 06, 2017 11:24 am

Thanks Mark

Machine monkey · Post by **Machine monkey** » Mon Feb 05, 2018 5:16 pm

Still need one of these if anyone has one I can borrow buy? I also need an oil filter housing?

Machine monkey · Post by **Machine monkey** » Thu Feb 08, 2018 10:24 am

I have got a plenum but still need a oil filter housing to borrow if anyone has one.

Machine monkey · Post by **Machine monkey** » Thu Feb 08, 2018 10:52 am

I put my hand in my pocket and have brought one. I will have 2 going spare in the near future if anyone wants one.

Z4-forum.com

Z4-forum.com