Roof & Window issue after fitting regulator

[Squid]

This reset actually worked for me as I had the same problem which was driving me mad! Thanks for this, saved my sanity

[Scooba_Steve]

67 62 ... Notes on initializing power window unit
(from 04/2004)
Warning!
Danger of injury!
There is no anti-trapping protection during initialization.
Note:
Cars built prior and up to 04/2004 have no anti-trapping
protection and on the passenger side no toll closing function.
Initialization is performed on the power window switch of the
relevant door.
Requirements for correct initialization:
 Initialization with engine running
 Convertible top, doors and windows closed
Initialization comprises:
 Erasure of initialization
 Reinitialization
An initialization must be performed:
 In the event of malfunctions, e.g. no one-touch control
function, no opening or if available no comfort function is
possible
 After the power window drive has been replaced
 After work is carried out on the power window mechanism
 After a power supply interruption, e.g. disconnection of the
battery or disconnection of the power supply to the door
 After the door window glass has been removed and
installed or replaced
 After adjustment work on the door window glass
 After adjustment work on the convertible top
 After replacement of seals
Erasure of initialization:
 Open door window glass fully
 Operate power window switch in "Open" position four times
within 10 seconds
This erases initialization of the power window, anti-trapping
protection and toll function are inactive.
Check whether one-touch control (toll) function is inactive,
otherwise repeat procedure.
Reinitialization:
Avoid a break between the two steps!
 Open door window glass fully
 Operate and hold power window switch in "Close" position
(second switch stage)
 Once the upper end position has been reached, hold power
window switch in "Close" position for approx. 2 seconds
longer
 Open door window glass fully
 Operate and hold power window switch in "Close" position
(second switch stage)
 Once the upper end position has been reached, hold power
window switch in "Close" position for approx. 2 seconds
longer
This completes initialization.
Note:
Carry out function check (one-touch control function, antitrapping
protection and, if necessary, comfort function).

[Scooba_Steve]

Sorry can't post the PDF and it's too big for a screenshot, not sure why TIS shows a repeat at the end. When I have done it I've erased and checked no one touch works, opened fully and held for 2 sec, closed fully and held for 2 sec, then checked.