Not joined yet? Register for free and enjoy features such as alerts, private messaging and viewing latest posts and topics.

PDC Parking sensor problems.

Discuss problems you have had or are having with your Z4
User avatar
dhobbs
Senior Member
Senior Member
Posts: 1621
Joined: Mon Jul 16, 2012 5:33 pm

PDC Parking sensor problems.

Post by dhobbs » Fri Apr 28, 2017 1:40 pm

Hi guys
I'm having problems with my rear parking sensors. On engaging reverse i get a long beep followed by various other beeps.
I have listened to each sensor in turn and they all crackle the same so i can assume they are all ok.

I also have put my code reader on (autel) and there are no stored codes.
I've had a hairdryer on them if they have any water in them, but no luck.

I had this before and after cleaning the car the issue went away, but now it's back!
So any ideas?
Is there anything to clean them with? WD40, compressed air or contact cleaner? I personally would avoid WD40 as it leaves an oily coating.

Any suggestions?
3.0si roadster. Requisite stubby. Sound gen mod. LED numberplate lights. LED boot strip. Interior lights LED too. ZHP gearknob. Daily drive :driving:
Motor in boot. Bilstein B8 dampers. New radio, much better sounds :thumbsup:

User avatar
jabber
Lifer
Lifer
Posts: 3138
Joined: Mon Jul 05, 2010 9:23 am
Location: Hampshire

PDC Parking sensor problems.

Post by jabber » Fri Apr 28, 2017 3:09 pm

I would check the connections on the sensors had similar problems disconnected all plugs cleaned them up and sprayed them with wd40 and fault cleared
Z less again
14 E89 Z4 2.0 msport grey gone now
10 E89 Z4 3.0 Black auto now. Very sadly gone
Gone 04 E85 z4 3.0 Maldives blue smg

User avatar
dhobbs
Senior Member
Senior Member
Posts: 1621
Joined: Mon Jul 16, 2012 5:33 pm

PDC Parking sensor problems.

Post by dhobbs » Fri Apr 28, 2017 5:33 pm

jabber wrote: Fri Apr 28, 2017 3:09 pm I would check the connections on the sensors had similar problems disconnected all plugs cleaned them up and sprayed them with wd40 and fault cleared
Thanks. I assume it a bumper off job?
3.0si roadster. Requisite stubby. Sound gen mod. LED numberplate lights. LED boot strip. Interior lights LED too. ZHP gearknob. Daily drive :driving:
Motor in boot. Bilstein B8 dampers. New radio, much better sounds :thumbsup:

User avatar
jabber
Lifer
Lifer
Posts: 3138
Joined: Mon Jul 05, 2010 9:23 am
Location: Hampshire

PDC Parking sensor problems.

Post by jabber » Fri Apr 28, 2017 8:19 pm

dhobbs wrote: Fri Apr 28, 2017 5:33 pm
jabber wrote: Fri Apr 28, 2017 3:09 pm I would check the connections on the sensors had similar problems disconnected all plugs cleaned them up and sprayed them with wd40 and fault cleared
Thanks. I assume it a bumper off job?
Yes but it's fairly easy to do
Z less again
14 E89 Z4 2.0 msport grey gone now
10 E89 Z4 3.0 Black auto now. Very sadly gone
Gone 04 E85 z4 3.0 Maldives blue smg

User avatar
dhobbs
Senior Member
Senior Member
Posts: 1621
Joined: Mon Jul 16, 2012 5:33 pm

PDC Parking sensor problems.

Post by dhobbs » Sun Apr 30, 2017 12:54 pm

Update.
Just had the bumper off a gave all the connections a clean with contact cleaner.
All back together and still the same fault :headbang:

On a plus side, i gave the crash bar a quick going over with hammerite and also give the exhaust tips a good polish.

So back to the PDC, what fuse is it? I may try and pull it to reset it.
Also where is the module located. May try reseating that too.

The battery is good and shows a green dot on the top so hopefully that's not causing it.
3.0si roadster. Requisite stubby. Sound gen mod. LED numberplate lights. LED boot strip. Interior lights LED too. ZHP gearknob. Daily drive :driving:
Motor in boot. Bilstein B8 dampers. New radio, much better sounds :thumbsup:

User avatar
dhobbs
Senior Member
Senior Member
Posts: 1621
Joined: Mon Jul 16, 2012 5:33 pm

PDC Parking sensor problems.

Post by dhobbs » Sun Apr 30, 2017 1:17 pm

Just did a Google and it's fuse number 8, a 5A fuse.
That's all good so maybe it's a trip to the stealers :cry:
3.0si roadster. Requisite stubby. Sound gen mod. LED numberplate lights. LED boot strip. Interior lights LED too. ZHP gearknob. Daily drive :driving:
Motor in boot. Bilstein B8 dampers. New radio, much better sounds :thumbsup:

User avatar
dhobbs
Senior Member
Senior Member
Posts: 1621
Joined: Mon Jul 16, 2012 5:33 pm

PDC Parking sensor problems.

Post by dhobbs » Mon May 01, 2017 8:27 pm

Bump, any suggestions?
3.0si roadster. Requisite stubby. Sound gen mod. LED numberplate lights. LED boot strip. Interior lights LED too. ZHP gearknob. Daily drive :driving:
Motor in boot. Bilstein B8 dampers. New radio, much better sounds :thumbsup:

SonnyA85
Senior Member
Senior Member
Posts: 1084
Joined: Tue Apr 12, 2016 7:42 pm

PDC Parking sensor problems.

Post by SonnyA85 » Tue May 02, 2017 12:47 pm

i have the same issue.

i have learned to just live with the fact they don't work.

i asked a local bodyshop garage to have a look at it and they said the front left of the car had some parts missing underneath which houses the temp sensor and the wiring for the parking sensors.

however all the sensors have power so i'm sure they were talking crap. i removed battery for 30 mins which reset my programmable seats but never fixed it.

if you find a fix let me know.

Any1else
Member
Member
Posts: 298
Joined: Wed Jan 27, 2016 5:20 pm

PDC Parking sensor problems.

Post by Any1else » Tue May 02, 2017 4:56 pm

I had the same thing here http://z4-forum.com/forum/viewtopic.php?f=3&t=95686

I replaced two of the non working sensors and cleared the codes but the system still didnt work despite all the sensors "pulsing" on reverse. I ended up removing the bumper and disconnecting all the sensors. Then I reconnected them, cleared the codes and checked I was getting a reading on the Intravee for the sensors. I discovered some wouldnt give a reading despite "pulsing". I figured they had to be ok so I swapped them around and put them into different sensor holes in the bumper. I finally found a combination that worked and have run with it. Now they all work - they all show a reading on the Intravee and beep when an object is detected. Only thing they dont do is beep when I engage reverse. Will have to look at that.
Last edited by Any1else on Tue May 02, 2017 7:31 pm, edited 1 time in total.
2003 Launch car : 3.0 litre E85 in Sterling grey

User avatar
bladeowner
Senior Member
Senior Member
Posts: 1453
Joined: Wed Apr 18, 2012 7:40 pm
Location: Yorkshireman in High Wycombe

PDC Parking sensor problems.

Post by bladeowner » Tue May 02, 2017 5:20 pm

OP. I found disconnecting the connectors to the PDC module in the boot and cleaning the contacts with contact cleaner cured my problem.
The module is in the boot at the RHS near the boot light.
Remove the rear lamps cover, pull out the carpet plastic rivet underneath.
Fold down the carpet a bit near the boot light and unscrew the bottom 10mm plastic nut of the module bracket and the top unhooks from the metal band. There are 2 connectors to the module.
Hope this works for you.
2004 Sapphire Black 2.5 SE Z4 SMG

User avatar
dhobbs
Senior Member
Senior Member
Posts: 1621
Joined: Mon Jul 16, 2012 5:33 pm

PDC Parking sensor problems.

Post by dhobbs » Tue May 02, 2017 6:28 pm

Found the PDC unit in the boot, now to disconnect and clean it up.

Have got a mate who's going to attach it to his pc to see if any codes are there! My code reader shows nothing.

Just looking on realoem and my colour doesn't seem to show up for the parking sensors. Just want to double check part numbers before getting a replacement. (Montego blue by the way)
3.0si roadster. Requisite stubby. Sound gen mod. LED numberplate lights. LED boot strip. Interior lights LED too. ZHP gearknob. Daily drive :driving:
Motor in boot. Bilstein B8 dampers. New radio, much better sounds :thumbsup:

User avatar
Worcester_spoon
Senior Member
Senior Member
Posts: 1542
Joined: Sat Apr 30, 2011 5:53 pm
Location: Basingstoke, Hampshire

PDC Parking sensor problems.

Post by Worcester_spoon » Tue May 02, 2017 6:43 pm

SonnyA85 wrote: Tue May 02, 2017 12:47 pm i have the same issue.

i have learned to just live with the fact they don't work.
This ^
03 Z4R 3.0i/Silver/custom quad/330d brake upgrade/LSD/G-Power supercharger/FIC 365cc injectors/Severn Tuning map

User avatar
dhobbs
Senior Member
Senior Member
Posts: 1621
Joined: Mon Jul 16, 2012 5:33 pm

PDC Parking sensor problems.

Post by dhobbs » Tue May 02, 2017 7:09 pm

PDC unit out and connections all cleaned using contact cleaner (5 minute job).

Still no change :headbang:

Next step I think is to buy another sensor and try each on in turn.

Thanks for all the advice so far.
Daz
3.0si roadster. Requisite stubby. Sound gen mod. LED numberplate lights. LED boot strip. Interior lights LED too. ZHP gearknob. Daily drive :driving:
Motor in boot. Bilstein B8 dampers. New radio, much better sounds :thumbsup:

User avatar
dhobbs
Senior Member
Senior Member
Posts: 1621
Joined: Mon Jul 16, 2012 5:33 pm

PDC Parking sensor problems.

Post by dhobbs » Wed May 03, 2017 8:11 am

Update.
Firstly and importantly my sensors work now. Yippee.

Secondly I've been an idiot. In testing my sensors I parked normally on my drive, which is close to a wall. So whilst I was testing it was of course beeping because it was either foo-barred or working correctly. :oops:
Of course taking the bumper off and reseating all the connections was away from the wall.
So how did I fix my problem, well it was either spraying a diluted car shampoo onto the sensors and agitating with a toothbrush, or by reseating the PDC unit in the car.
Either way, it works (for now).
Daz
3.0si roadster. Requisite stubby. Sound gen mod. LED numberplate lights. LED boot strip. Interior lights LED too. ZHP gearknob. Daily drive :driving:
Motor in boot. Bilstein B8 dampers. New radio, much better sounds :thumbsup:

SonnyA85
Senior Member
Senior Member
Posts: 1084
Joined: Tue Apr 12, 2016 7:42 pm

PDC Parking sensor problems.

Post by SonnyA85 » Wed May 03, 2017 10:36 am

you got any pics of where this unit is and hot to get into it? what tools do I need?

i'm a bit of a noob when it comes to this stuff so i will need a complete idiots guide. all my sensors tick so i will just clean up the connections, re-attach and then test.

Post Reply