Page 1 of 1

Rear Indicator light

Posted: Tue Nov 14, 2017 6:01 pm
by Hellequin
Is it easy to replace a rear indicator LED string, and do whatever is needed to stop the condensation? Mine has blown and all I am being told is contact BMW, which I am assuming would cost squllions

Rear Indicator light

Posted: Tue Nov 14, 2017 7:03 pm
by mcbutler
I believe you have to change the entire rear lamp assembly....

Part number left hand side 63217191775
Part number right hand side 63217191776

Type the part numbers into ebay, you will be looking at around £100 - £140

Rear Indicator light

Posted: Tue Nov 14, 2017 8:05 pm
by Hellequin
2 things: do these come with the LEDs fitted? which ones will match the originals as I would only be replacing the offside one?

Rear Indicator light

Posted: Tue Nov 14, 2017 8:41 pm
by Maniac
They come as a working unit. Have you tried eBay?

Rear Indicator light

Posted: Tue Nov 14, 2017 9:29 pm
by Hellequin
I see there are quite a few on there, just been watching a video on removing them. Must look again and see if I can do it :)

Rear Indicator light

Posted: Tue Nov 14, 2017 9:37 pm
by Gaffa22
Not too difficult, just removed both of mine and sealed them, didn't have a condensation problem but noticed the separation along the bottom edge
Car always been garaged so I think that helped.

Rear Indicator light

Posted: Tue Nov 14, 2017 9:59 pm
by Nictrix
Look on ECP as well and wait for a good discount.

Rear Indicator light

Posted: Wed Nov 15, 2017 8:59 am
by Zikim
Gaffa22 wrote:
Tue Nov 14, 2017 9:37 pm
Not too difficult, just removed both of mine and sealed them, didn't have a condensation problem but noticed the separation along the bottom edge
Car always been garaged so I think that helped.
Did you separate the lens from the body and if so, how did you do this?

Rear Indicator light

Posted: Wed Nov 15, 2017 1:29 pm
by Gaffa22
Zikim wrote:
Wed Nov 15, 2017 8:59 am
Gaffa22 wrote:
Tue Nov 14, 2017 9:37 pm
Not too difficult, just removed both of mine and sealed them, didn't have a condensation problem but noticed the separation along the bottom edge
Car always been garaged so I think that helped.
Did you separate the lens from the body and if so, how did you do this?
No you can't separate the unit, there are a few threads on here about rear light water ingress.
I followed the instructions i found, but basically you remove the centre black part that clips round the bulb holders and seal with silicone, also
check the bottom of the cluster to see if the lens has started to separate from the grey body, seal this with clear silicone.

Rear Indicator light

Posted: Mon Nov 20, 2017 6:15 pm
by Hellequin
Got new cluster from eBay, took a bit of fiddling to get the old one out, new one now in and all good :)