Z4-forum.com

inkey$, do like that. Good work.

Have you seen the spec doc version, $150 though
http://stores.homestead.com/2point5/-st ... Detail.bok

Have you considered Proclip? They have a couple options and also a phone holder that is wireless charging. You'll need to open the ashtray though but this is one of the cleanest setups IMO

https://www.proclipusa.com/vehicle/dash ... mw-z4/2006

https://www.proclipusa.com/product/1003 ... ilt-swivel

Holy thread revival!

Strangely I'm on the same project all these years later. Going Brodit I think.

inkey$ wrote: ↑Thu Dec 31, 2020 7:31 pm
Strangely I'm on the same project all these years later. Going Brodit I think.

Make sure you update all your photos lol

kis wrote: ↑Thu Jan 07, 2021 10:16 pm

inkey$ wrote: ↑Thu Dec 31, 2020 7:31 pm
Strangely I'm on the same project all these years later. Going Brodit I think.

Make sure you update all your photos lol

Yeah I will. Just waiting for the Brodit clip and holder before sussing it all out with hardwiring etc.

inkey$ wrote: ↑Thu Jan 07, 2021 11:22 pm Yeah I will. Just waiting for the Brodit clip and holder before sussing it all out with hardwiring etc.

Did you finish this inkey$?
Would love to see some pics or see what you went for.

Street wrote: ↑Tue Jun 15, 2021 11:21 pm

inkey$ wrote: ↑Thu Jan 07, 2021 11:22 pm Yeah I will. Just waiting for the Brodit clip and holder before sussing it all out with hardwiring etc.

Did you finish this inkey$?
Would love to see some pics or see what you went for.

Not yet Brodit is in by not tackled the wiring yet. Funnily enough, I just switched to iPhone, so looking to see if theres another Magsafe way to hold and charge my phone (hardwired holder/charger)

Current setup with Brodit….
viewtopic.php?f=2&t=125819&start=90

Also, after living with the Brodit for a few months, whilst its great its situated to my left which isn't idea for those of us right handed. If I go Magsafe I may try to figure out a way of locating back over to the right of the steering wheel.