Z4-forum.com

does anyone have pdf or diagram for how can i cut dash?
any measurement?
or any pdf for template?

You might be better trying a breakers for a dash top from a nav car

On eBay i think it's classiccarspares2016

Nothing like that...

Just do as I did and make your own. Just remember you can make the hole bigger, but not smaller.

eBay number 263152522471

I just need template with paper to cut , not compleatly dash bro

I have fitted two of these, if you take a thin piece of cardboard it is easy to make the cutout and you can test it using the screen. Point to remember is that there is a small edge at the front that you don't remove and the legs of the screen have holes that need to lign up with the screws under the dash surface.

That's not a bad price. THey were £200 when I did mine and was looking for a just in case solution

ah yes, your rush job

I took 3 evenings if I remember well, to avoid the just in case ... measure, re-measure, cut, cut a bit more etc

You did take 3 years to finish it off though

Never again though.

I did the measure twice cut once stuff, but the concern was the dremel slipping, although I did protect the dash the best I could.

3 years, you checky fecker

Where you been hiding anyway, not that we've missed you

hello

I want to upgrade navi system to my bmw z4 2006 , i buy radio professional and monitor, what else do I need to do?
What is the catalog number of the cables?

Best regards

i need wiring loom serial number 61120301701

Where can i find a cutting template?

Template original: EBA 0129201834

cost 1$ in bmw