Recent content by jamiecarpenter

Im finally getting around to swapping my rusty door out and putting on the one enuff-zed sold me last year. Has anyone done this? Any advice? The do's and don'ts? Strip the door first or remove the door first? Ive had a look on the forum but havent really found anything on it other than...

I’m having trouble finding a supplier for a blue heated wing mirror with backing plate. Everyone I seem to find has the heating element connector in the wrong place. My cable is located on the furthest part of the mirror from the car. All the one's I keep finding have the connector nearest...

Hope someone maybe able to help here. My side light bulb went off today then went back on when I then drove it later in the day. I swapped out the bulb for another that worked I then put it back in the headlight and it then failed. I then swapped that out and couldn't get any to work. (x4)...

I've had a pair of halo headlights fitted for about ten years. Unfortunately they began to fail and i tracked it to corroded pins in the wiring blocks. I thought I had sorted it out but the issue came back with double speed indicators. Due to this I went back to second hand oem headlights...

Selling A E85 boot lid silver grey A08. In good condition apart from a small rust patch by the lock. As pictured. £10 collection only Coventry.

I currently have the 2xcite halo lights fitted to the z4 which has the motors in them. These replaced a set of xenon headlights as they started to let moisture in and it ruined the inners. I had these fitted over 10 years ago by a local garage. They did have a few issues with fitting them as...

My PDC has stopped working. I've checked the fuse which is fine. I have looked at the module for any damage or water ingress and there isn't. So I then decided to put it in reverse and try and hear the clicking noise. However I can't hear any clicking from any of them. Question I firstly...

Ive just swapped out my old boot lid for a second hand one due to a little rust. All has gone well until I was tightening up the bolts on the boot lid which attaches to the hinges. I stupidly didn't measure up the shut lines before taking the old one off. My main concern is how close the back...

I fitted my hard top for the winter a few weeks ago. The hood was bone dry when it was put down. I havent used the car in two weeks and today when I opened the boot, the underside of the lid was soaked in condensation. I put the hard top on to help keep the hood and car dry over the winter...

I've had real difficulty replacing the gel pad that sticks the sensor to the windscreen. Ive tried the m3 pad which I cant sit correctly without causing bubbles (Gone through 5 of these). I then tried an alternative thicker pad from amazon which was easier to apply but have just discovered the...

Hi Im after a z4 e85 screw cover that is situated in the air vent on the dash board. Looks like a small black sugary sweet. Has anyone got one they wish to sell?

Im after a z4 e85 Knee pad passenger side. Just broken mine trying to remove it.

I needed to replace my rain sensor gel pad due to air bubbles. Ive had one attempt. I put the gel firstly on the screen then attached the lens to it. Unfortunately it did not go well and i ended up pulling it off. I have one gel pad left. Has anyone managed to sucessfully replace one and...

My key has stopped locking the car but still unlocks the car and the boot without issue (using the fob rather than putting the key in the locks). Anyone else had this issue. Everything else seems to be fine with the car. Im hoping its not down to the GM5 module.

Hi don't suppose you have drivers side headlight wiring harness? Cheers Jamie