Gala control speed sensitive

bmwstuff · Post by **bmwstuff** » Wed Aug 01, 2007 4:36 pm

Hi,

Can anyone remind me how to get into the gala speed sensitive control menu. I read it on z4um about accessing the special menu.

Any help appreciated?
Thanks.
Dan

Post by **Wondermike** » Wed Aug 01, 2007 9:32 pm

You need to press the "music note" button and cycle through to find the menu for it

bmwstuff · Post by **bmwstuff** » Fri Aug 03, 2007 5:29 pm

cheers will give it a try

bmwstuff · Post by **bmwstuff** » Thu Aug 09, 2007 2:09 pm

doesnt seem to work, it just shows the bass, treble and fader controls.
anyone any ideas?

thx

Sephanite · Post by **Sephanite** » Thu Aug 09, 2007 3:20 pm

u just pressed the music note. u gotta 'hold' it down first and dont let go until it changes

bmwstuff · Post by **bmwstuff** » Mon Aug 20, 2007 11:55 am

thx, kept holding onto the "music note" button for a long time and no change. I have the standard speaker system with pop up satnav if that might be the difference?
Any other ideas, I know I accessed the menu before when I updated the satnav software but cant remember now!

bmwstuff · Post by **bmwstuff** » Mon Aug 20, 2007 1:08 pm

tried this:
Go to the main menu and then settings. Press the menu button for about 10 seconds until a new menu appears.
Gets to the satnav menu but the gala controls are not there either?
Any ideas as the automatic gala control is set too sensitive at the moment?

R32Paul · Post by **R32Paul** » Mon Aug 20, 2007 7:42 pm

If you have a NAV car then you have to press and hold the SEL button with the key in position 1 or 2, you then get the serial number and you can then change the options with the < and > buttons.

I think that is correct, it was on z4UM but I found it via google....

Paul

bmwstuff · Post by **bmwstuff** » Tue Aug 21, 2007 5:43 pm

thanks r32paulbut still cant get it to work

found this tho and will give it a try:

Speed-sensitive volume control setting
This feature allows you to increase or decrease the speed sensitive volume with the Business Radio as well as put your radio in different country modes (such as Europe mode). This doesn't work on all radio options, but give it a shot:

First, don't be driving while doing this procedure ! !

Turn the radio off then on again. Don't touch any button except the 'm' button - the button you use to tune the radio frequency manually.
Press and hold the 'm' button for TEN seconds or until the display changes. IIRC, it shows the serial number of the unit.
Normally when you press 'm', the display will reflect that by replacing 'ST' (stereo tuning) with 'm'.
When holding the 'm' button for this procedure, the display should not do this - you will continue to see 'ST' for the ten seconds.

Now if the display has changed, you are in a configure mode on the radio.
If you press the '+' or '-' button you change modes.
The mode you want will display as "GAL (1-6)".
This mode allows you to adjust the speed-sensitive volume control.
Use the radio preset buttons 1-6 to set the amount of volume change you want at speed.
Setting 1 is the Smallest change, 6 is the Largest – highest amount of change.
Stock setting from factory is "3"

bmwstuff · Post by **bmwstuff** » Fri Aug 24, 2007 8:23 am

doesnt work either

bmwstuff · Post by **bmwstuff** » Wed Aug 29, 2007 4:30 pm

solved it!
think r32paul was partly right. will post on how to

Z4-forum.com

Z4-forum.com

Gala control speed sensitive

Gala control speed sensitive

thx

doesnt seem to work

thx

tried this

thanks

doesnt seem to work

solved it