hi,
the right front fog light was damaged by a stone. I will pick up a new one from ebay. Is it a difficult job to replace this unit? Any hints?
thanks!
Not joined yet? Register for free and enjoy features such as alerts, private messaging and viewing latest posts and topics.
how to replace a fog light unit?
-
- Newbie
- Posts: 18
- Joined: Mon Jun 14, 2010 11:07 am
how to replace a fog light unit?
2004 Z4 2.5i - spacegrau
- pvr
- Legend
- Posts: 26455
- Joined: Fri Jun 15, 2007 12:27 pm
- Location: South East UK
Re: how to replace a fog light unit?
Replacement is done by working from the inside of the wheel arch. You can remove the flap to give you access.
Current:
911-50 Black - unique spec
X5M - 575 hp of fun in a V8
Abarth 595 Comp.
Golf Clipper - collectors item
Z4 3.0si Black Sapphire
VW ID.3
Previous:
Z4M Silver Grey - non flimper spec (gone to Bing)
Z4 3.0 Toledo
911-50 Black - unique spec
X5M - 575 hp of fun in a V8
Abarth 595 Comp.
Golf Clipper - collectors item
Z4 3.0si Black Sapphire
VW ID.3
Previous:
Z4M Silver Grey - non flimper spec (gone to Bing)
Z4 3.0 Toledo
-
- Newbie
- Posts: 18
- Joined: Mon Jun 14, 2010 11:07 am
Re: how to replace a fog light unit?
so just jack up the right front wheel, put it on an axle stand, and work from the inside of the bumper/wheel arche?pvr wrote:Replacement is done by working from the inside of the wheel arch. You can remove the flap to give you access.
2004 Z4 2.5i - spacegrau
- pvr
- Legend
- Posts: 26455
- Joined: Fri Jun 15, 2007 12:27 pm
- Location: South East UK
Re: how to replace a fog light unit?
Yep. You may find it easier to remove the wheel, but it is not required as such. You can reach all the parts from inside.
Current:
911-50 Black - unique spec
X5M - 575 hp of fun in a V8
Abarth 595 Comp.
Golf Clipper - collectors item
Z4 3.0si Black Sapphire
VW ID.3
Previous:
Z4M Silver Grey - non flimper spec (gone to Bing)
Z4 3.0 Toledo
911-50 Black - unique spec
X5M - 575 hp of fun in a V8
Abarth 595 Comp.
Golf Clipper - collectors item
Z4 3.0si Black Sapphire
VW ID.3
Previous:
Z4M Silver Grey - non flimper spec (gone to Bing)
Z4 3.0 Toledo
-
- Newbie
- Posts: 18
- Joined: Mon Jun 14, 2010 11:07 am
Re: how to replace a fog light unit?
is this the same unit as on a e46? they look very similar
2004 Z4 2.5i - spacegrau
- Ian Hammond
- Member
- Posts: 74
- Joined: Tue May 04, 2010 8:54 pm
- Location: Deepest Darkest East Anglia
Re: how to replace a fog light unit?
I had to replace one of mine a couple of months ago - similar story got back from a great day out and found a hole in the glass dead centre of the NS fog light I picked up a replacement off eBay for about £20 - bargain I think there are a couple for the pre- face lift on ebay at the moment.
Replacement is very simple through the access panel in the wheel arch liner. 3 posidrive screws and the bulb connection. Should take about 1/2 hour all in.
I did jack up the front corner and remove the wheel for better access.
Ian.
Replacement is very simple through the access panel in the wheel arch liner. 3 posidrive screws and the bulb connection. Should take about 1/2 hour all in.
I did jack up the front corner and remove the wheel for better access.
Ian.
03 - 2.5 - Titanium Silver - 107's - Xenons - 10 Speaker Upgrade - Electric memory heated seats - MFSW - PDC - Cruise - ZHP - Folding Mirrors - Aux Cable - gapTech 1Touch - No Stubby