Z4-forum.com

On my to do list after my holiday

Cannon1891 wrote: ↑Sun Aug 06, 2023 1:39 pm I've followed the steps above but have a slight flicker/pulse about once every second. I've used the Qasim lights mentioned above from Amazon

You need to code out the bulb test feature in the LKM light module. The LKM tests bulbs by blasting a quick pulse thru them which, with LEDs and their fast response time, becomes visible.

Cheers Scott, Only had the car just over a week, lots of things to do, haven't yet got on to scanner/software etc. I might ask for some advice soon.
The pulse is hardly noticeable but will get dealt with at some point, I think I may add a drl relay for the halo's so they're off when the xenon/halogens are on, but that's making the job a little bigger than necessary at the moment.

Can the sidelights be coded to be off when dipped or main beam is on ? Or is this hard wired in?

You'll have to forgive my poor knowledge of the electrics, not my bag

Cheers,

Phil

There's various ways of removing the fur from the feline when it comes to coding. I always use NCSExpert which can be a bit hardcore but easier ones abound, although they don't always do every option.

There's all sorts of weird configuration things and, from memory, some of them might be to exclude one light when another comes on but it's a while since I played with them.