Not joined yet? Register for free and enjoy features such as alerts, private messaging and viewing latest posts and topics.
How do I removed a xenon bulb on the 2003?
-
- Newbie
- Posts: 4
- Joined: Thu Mar 11, 2021 12:09 am
How do I removed a xenon bulb on the 2003?
I've pulled, pushed, twisted, wiggled and nothing is budging. I'm not even sure where to bulb ends and the adapter begins. Guessing the metal ring is part of the bulb? Spent hours on youtube and forums and found nothing helpful. The only examples are later models, which have different assemblies. Any help is much appreciated.
- Chris_D
- Lifer
- Posts: 6615
- Joined: Thu Apr 21, 2016 11:41 pm
- Location: Mostly Holland. Sometimes UK.
How do I removed a xenon bulb on the 2003?
That looks like a bodge to me.
The bulb should be held in place via a clip and the igniter which screws onto the back of the headlight housing.
Does the other side look the same?
How did you remove the igniter?
Edit:
looking a bit closer at your photo, you probably can't remove that connector as whoever has bodged it together probably soldered the wires to the bulb connectors. It may even have been supplied like that from an aftermarket supplier.
It's def not standard but doesn't look so dangerous, at least the bulb end looks like it's isolated well with a double sheath and at the other end they enter the terminal block of what I suspect is the igniter unit which is probably aftermarket and look isolated.
I hope you disconnected the battery before fiddling around? There's some considerable voltages knocking around xenon headlights!
The bulb should be held in place via a clip and the igniter which screws onto the back of the headlight housing.
Does the other side look the same?
How did you remove the igniter?
Edit:
looking a bit closer at your photo, you probably can't remove that connector as whoever has bodged it together probably soldered the wires to the bulb connectors. It may even have been supplied like that from an aftermarket supplier.
It's def not standard but doesn't look so dangerous, at least the bulb end looks like it's isolated well with a double sheath and at the other end they enter the terminal block of what I suspect is the igniter unit which is probably aftermarket and look isolated.
I hope you disconnected the battery before fiddling around? There's some considerable voltages knocking around xenon headlights!
Last edited by Chris_D on Thu Mar 11, 2021 12:50 pm, edited 2 times in total.
E85 3.0i roadie (03) 'Benny'. E93 320d M-Sport Cabrio (11) 'Bob'.
'Always different, always the same.' John Peel on The Fall.
'Always different, always the same.' John Peel on The Fall.
- dhobbs
- Senior Member
- Posts: 1621
- Joined: Mon Jul 16, 2012 5:33 pm
How do I removed a xenon bulb on the 2003?
Yeah, not standard at all. Doesn't look like mine at all.
Does the bulb still work or are you replacing them?
Do you know if the car has been upgraded to xenon?
Does the bulb still work or are you replacing them?
Do you know if the car has been upgraded to xenon?
3.0si roadster. Requisite stubby. Sound gen mod. LED numberplate lights. LED boot strip. Interior lights LED too. ZHP gearknob. Daily drive
Motor in boot. Bilstein B8 dampers. New radio, much better sounds
Motor in boot. Bilstein B8 dampers. New radio, much better sounds
-
- Newbie
- Posts: 4
- Joined: Thu Mar 11, 2021 12:09 am
How do I removed a xenon bulb on the 2003?
Yes, looking into replacing the bulb. It often turns on for a few minutes before going out. Hope it's not a bigger issue. Was going to try swapping the bulbs to see if that fixes this lamp, but ran into the above problem.
Hadn't even considered I might be aftermarket. That would explain not finding any info on this setup. I've only had the car a couple years with next to no info from the previous owners. Pretty sure there was front end damage that was fixed, so wouldn't surprise me that the lamps are aftermarket.
I'm assuming the igniter is the metal box holding in the bulb that I've seen in diagrams and videos. This doesn't seem to exist in my assembly. There was just a thin metal clip that held the bulb in place.
So maybe there is a clip further up the wires. I'll go check it out.
Hadn't even considered I might be aftermarket. That would explain not finding any info on this setup. I've only had the car a couple years with next to no info from the previous owners. Pretty sure there was front end damage that was fixed, so wouldn't surprise me that the lamps are aftermarket.
I'm assuming the igniter is the metal box holding in the bulb that I've seen in diagrams and videos. This doesn't seem to exist in my assembly. There was just a thin metal clip that held the bulb in place.
So maybe there is a clip further up the wires. I'll go check it out.
-
- Newbie
- Posts: 4
- Joined: Thu Mar 11, 2021 12:09 am
How do I removed a xenon bulb on the 2003?
Update: These are in fact aftermarket Hella lamps, a slightly different part number from these. Pulling the bulb assembly out further, it looks like the wires clip in. Now I've hit another wall. I don't see any xenon bulbs on the market that come with wiring like this. Also I haven't been able to find any installation or bulb replacement videos that might shed light on what I'm dealing with.
As stated before, the bulb itself does not budge and there is no noticeable seam where I would expect it to detach. Either it's really jammed, there's some trick to detaching the bulb that I can't figure out, or it's built into the wiring as a pre-assembled product I can't seem to find.
Your thoughts would be much appreciated
As stated before, the bulb itself does not budge and there is no noticeable seam where I would expect it to detach. Either it's really jammed, there's some trick to detaching the bulb that I can't figure out, or it's built into the wiring as a pre-assembled product I can't seem to find.
Your thoughts would be much appreciated
- Attachments
-
- PXL_20210313_014307434.jpg (207.75 KiB) Viewed 2269 times
-
- PXL_20210313_014400937.jpg (219.57 KiB) Viewed 2269 times
-
- Member
- Posts: 703
- Joined: Sun Sep 02, 2018 12:47 am
- Location: Shropshire
How do I removed a xenon bulb on the 2003?
they look perfectly stock to me for an aftermarket kit. Most seem to have long leads and connectors on the bulbs. example being here https://www.amazon.co.uk/Xenon-Conversi ... NrPXRydWU= this is just a random kit I found on Amazon. HTH
Ex E86 Z4 3.0si coupé facelift blue now Z'less
Porsche 997 C2S black-gone-, Mazda Eunos 1.8 yellow-gone-, Audi S4 Avant v6 Quattro 3.0 supercharged red-gone. Abarth 500 red. Abarth 124 Spider GT black. Porsche Cayenne red.
Porsche 997 C2S black-gone-, Mazda Eunos 1.8 yellow-gone-, Audi S4 Avant v6 Quattro 3.0 supercharged red-gone. Abarth 500 red. Abarth 124 Spider GT black. Porsche Cayenne red.
-
- Newbie
- Posts: 4
- Joined: Thu Mar 11, 2021 12:09 am
How do I removed a xenon bulb on the 2003?
Oh nice, that looks right! I just didn't know what to search for.